1. Motors (4 pieces)
Type: Brushless DC Motor
KV Rating: 1000KV (typically used for F450 frame drones)
Max Thrust: 950g with 1045 propellers
Operating Voltage: 2-4S LiPo (7.4V - 14.8V)
Max Current: 22A
Shaft Diameter: 5mm
Weight: Approx. 60g each
2. Electronic Speed Controllers (ESC) (4 pieces)
Type: Brushless ESC
Current Rating: 30A (constant), 40A (burst)
BEC Output: 5V, 3A (provides power to the flight controller and other electronics)
Input Voltage: 2-4S LiPo (7.4V - 14.8V)
Firmware: BLHeli or SimonK (depending on the model)
Connectors: 3.5mm bullet connectors (motor), XT60 or JST connectors (power input)
3. Propellers (2 pieces)
Size: 10x4.5 inches (1045)
Material: Plastic (typically ABS or nylon reinforced)
Rotation: One CW (clockwise) and one CCW (counterclockwise)
Mounting: Direct fit on motor shafts with adapter rings
4. F450 Frame (1 piece)
Material: Glass fiber + polyamide nylon
Dimensions: 450mm motor to motor
Weight: Approx. 300g
Mounting Holes: Compatible with various flight controllers (like KK2, APM, Pixhawk)
Features: Integrated power distribution board (PDB) for easy wiring
5. Strap Belt (1 piece)
Material: Nylon or Velcro
Length: 20-25 cm
Width: 2 cm
Usage: Secure the battery to the drone frame

2.4G Wireless Wi-Fi Telemetry Module With Antenna For Pixhawk APM MiniAPM Flight Controller

It support Mobile Computer and can replace the 3DR data transmission module and free you from the limitation of USB cable.
It is suitable for all flight control with TTL interface.

Range:-
More Than 100 meter Range open Field

Wireless Module:-
FCC compliant
Wi-Fi standard: 802.11 b/g/n
Frequency Range: 2.4G-2.5G (2400M-2483M)
Size: 18.5 x 26mm
Suitable For: Pixhawk, APM2.5/2.6, Mini APM

Transmit power:
- 802.11 b: +20dBm
- 802.11 g: +17dBm
- 802.11 n: +14dBm

Receive power:
- 802.11 b: -91dBm (11Mbps)
- 802.11 g: -75dBm (54Mbps)
- 802.11 n: -72dBm (MCS7)

Connect data:
- SSID: Velocity-i2
- Code: ardupilot
- Ground IP: 192.168.4.1
- Protocol: UDP
- Board rate: 57600

Usage:
1. Directly insert in the flight control's data transmission port. When powered , there will be a Wi-Fi named APMWIFI, the password is ardupilot. If connect successfully, it will distribute you an IP address192.168.4.2.
2. Turn on ground station software, set connect as UDP protocol, 57600 Board rate, 14500 connect port.